Hey all, I have 2 layer 3 switches connected to each other over an l3 WAN link, switch A has a DHCP server connected to it with Svi's set up and dhcp helper addresses, my qustion is on the second switch to get to that dhcp server will it need ip addr...
hey all, i am implemening a 4507 switch at a new site, was just wounder what cmd's i would need to implement auto QoS? the phones are non cisco phones. can i implement QoS on a per vlan basis's or can it only be done via a port basis?
Hey All, i get this from an AP any ideas why this may be happening? Last Error Occurred Failed to send Lwapp discovery response Last Error Occurred Reason Discovery response message header encapsulation failed Last Join Error Timestamp Sep 19 15:56:...
plc-sw-core#enplc-sw-core#shplc-sw-core#show ip roplc-sw-core#show ip route Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 ...
thanks for that, on the 4507 will i still need the helper-addresses under the interfaces? ( im only putting the interfaces on the 4507 for cosmetic value).
thanks guys, above is the diagram of the network, the 3750 has the dhcp server and the GW Svi's on it. the 4507 is the new switch that is being implemented and os on the other side of the l3 link. the 4507 needs to have the same vlan's ( will need t...
try removing preept and readding the cmd? do you have tracking on an interface? may be best to remove preept all together ( i know its not ideal but may be best)
