Hi,
A small question for cisco experts, but not totaly clear for me.
When I type the following command
Catalyst4507#sh qos int gigabitEthernet 4/23
QoS is disabled globally
Port QoS is enabled
Administrative Port Trust State: 'untrusted'
Operational Port Trust State: 'dscp'
Trust device: none
Default DSCP: 0 Default CoS: 0
Appliance trust: none
Tx-Queue Bandwidth ShapeRate Priority QueueSize
(bps) (bps) (packets)
1 31250000 disabled N/A 292
2 31250000 disabled N/A 292
3 31250000 disabled normal 292
4 31250000 disabled N/A 292
Catalyst4507#sh qos
QoS is disabled globally
IP header DSCP rewrite is enabled
So qos is disabled on my switch, but why is my port then handeling QOS markings??
Catalyst4507#sh platform hardware interface gigabitEthernet 4/23 statistics
Switch Phyport Gi4/23 Non-Zero Hardware Statistics
RxDot1qTaggedPackets : 140488853
TxDot1qTaggedPackets : 426892082
RxIpHeaderGoodPackets : 139917259
TxBytesQueue0 : 1761227
TxBytesQueue1 : 1943398034
TxBytesQueue2 : 4248900035
TxBytesQueue3 : 254018296
Cos RxBytes TxBytes RxPackets TxPackets
------------------------------------------------------
0 2302949265 2879591462 93608884 334159159
1 536253661 446 2959676 5
2 674978444 886324774 7507737 10810088
3 88139946 13242 209345 37
4 426631834 0 1779828 0
5 0 490019220 0 7206165
6 496889915 77300 34423383 793
7 0 1084572824 0 74715835
Does it have something to do with the "Port QoS is enabled" and if so how can I disable this?
Any help much appreciated.
Kind regards
St
