09-18-2014 09:01 AM - edited 03-07-2019 08:48 PM
Hello,
Scenario:
I have C2960X- 48 gigabit Ethernet ports.
At the other end are computers.
Problem - Question:
The computer is turned off (not on standby),
But status of port is up ...
GigabitEthernet1/0/10 is up, line protocol is up (connected)
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
Here is show run:
interface GigabitEthernet1/0/10
description Gi1/0/10 Port - 10
switchport access vlan 350
switchport mode access
switchport voice vlan 290
storm-control broadcast level pps 50
storm-control action shutdown
spanning-tree portfast
end
There is only one PC connected, and PC is off.
Why I have port up and Full-fuplex, 10Mb/s?
Thank you in advance for any help you can provide.
Solved! Go to Solution.
09-18-2014 10:00 AM
this issue should be given to the manufacturer network card
09-18-2014 10:07 AM
This behaviour is normal if your PC is TURNED OFF and not POWERED OFF.
When you turn off the PC, the power is still enabled. This NIC card is active due to Wake-on-LAN. So the NIC listens out for the "magic packet".
09-18-2014 10:00 AM
this issue should be given to the manufacturer network card
09-18-2014 11:11 AM
Thanks to both of you.
Regards,
09-18-2014 03:16 PM
Thank you for taking the time to rate our posts. :)
09-18-2014 10:07 AM
This behaviour is normal if your PC is TURNED OFF and not POWERED OFF.
When you turn off the PC, the power is still enabled. This NIC card is active due to Wake-on-LAN. So the NIC listens out for the "magic packet".
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide