Power issue on 3560

[kumarvin]

Hi

I am facing an issue regarding power issoe on PoE ports. I am getting this log %ILPOWER-5-ILPOWER_POWER_DENY:

After checking cisco web site regarding same, I observe below output.

1. %ILPOWER-5-ILPOWER_POWER_DENY: Interface [chars]:inline power denied

This message means that the PoE request was denied because the switch does not have enough power left to support the request. [chars] is the interface number.

Recommended Action: No action is required.

Related documents- No specific documents apply to this error message.

So Please suggest me what to do now.. As earlier everything is working fine but after replacing the faulty switch with another switch, I observed this issue.

Should I raise the RMA for this switch or any way to troubleshoot this issue?

Please Help.

Thanks in advance,

Regards

Vinod.

[ranraju]

are you seeing this issue on all the ports of the switch or on some ports...?

[dwillie]

what are the results of your show power inline command?  3560's show available/used/remaining stats.

[Steven Williams]

What do the POST startup tests show when you power cycle the switch?

[kumarvin]

Hi

ranraju @ :-- I am facing this issue only on few ports of the switch

Darren Willie @
When using show Power inline  CLI.. MAx is 370 W consume 358 W Free 12 W.

Also when using show power inline status

many of the ports showing Cisco PD and consuming Max power (15.6 W)

stevenjwilliams83@----- I haven't test this till yet.