Power-Stack 3750X - Budget Question

[Marcos_Castillo]

Hello Everyone

I have the following problem/question. I don't understand why the POWER BUDGET on the below picture are different for each switch. 

Based on the INLINE power, each switch is taking only 190W

Switch one: 510 + 190 = 700

Switch two: 515 + 190 = 705

Switch three 541 + 190 = 731

Switch four 480 + 190 = 670

Thank you

[Georg Pauwen]

Hello,

the Power-priority high and Power-priority low values are different for each switch in the stack (which is in power sharing mode), hence the different power budget values...

[Marcos_Castillo]

Thank you Georg

I executed the following command

SHOW POWER INLINE PRIORITY

I see that all of the ports are LOW. Is the another command that I'm missing?

FirstSecondThird

[Georg Pauwen]

Hello,

by default, all ports are set to low priority, unless you change that manually by entering the power inline port priority { high | low } interface configuration command...

[Marcos_Castillo]

Hello

I understand that but the reason I show you those screenshots was to confirm that all ports are in LOW priority and even in that case the BUDGET is different for all switches. That is what I'm trying to figure out.

Thank you

[Georg Pauwen]

Hello,

try and set the power high and low priority values to the same on all switches, and check if the power budget is the same then...

[Marcos_Castillo]

Priorities are the same in every single switch.

Still the same