09-06-2011 04:20 AM - edited 03-07-2019 02:04 AM
Hi ,
i have 3 nos of C3750 X PoE switches which are data and power stacked ,in that switch i connected 7 nos of Access Points which works on PoE.
so when i remove one power cable from the one switch . the PoE access points are not getting the power and under the access point interface it is showing as Power denied.
can any one suggest me what is the problem.
regards,
09-06-2011 05:44 AM
Hi Venkata,
Though I am new to 3750-X but with a little research I found this link, thought of sharing it with you.
Managing Catalyst 3750-X Stack Power
Regards,
Sunil.
09-07-2011 06:11 AM
Your problem description is not very clear. What do you mean when you say you remove only one power cable?
Are you aware of how much power does each access point require? Do you get any logs on 3750X as well indicating some problem with PoE? What exact model of 3750X switch you are using?
Sweta
09-07-2011 10:27 AM
Hi Venkata,
Please provide the following info--
1)How are power stack cables connected(i mean 1 to 2,then 2 to 3 etc.)
2)What is the power capacity of the three power supplies (350,715 or 1100)
09-07-2011 11:24 PM
hi sunil,
thanks for sharing the documnet.
hi swetha,
each ap is using 15.4 watt and all switches are confiured in power redundent mode.
out off 3 sw's 2 sw's are having only have the power source.when i reload the all sw's with this condition.aps are not getting the power,when sw's are configured in redundent mode.what is the problem?
we have 715 power suplly for every switch,but we connected only 2 power source to switches.
hi ankur,
switches power stackings are connected 1-2,2-3 and 3-1 wise.
when i configured the swithces in power sharing mode .its working,but its not working when its in redundent mode.what is the reason?
thanks and regards,
Venkat
09-08-2011 07:17 AM
Hi Venkat,
Just wanted to ensure that your total available power,and stack power connections are correct..I am not aware about redundant and power sharing mode.
09-08-2011 07:25 AM
This white paper has info about redundant and power sharing mode...Check if this helps you.
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/white_paper_c11-578931.html
09-09-2011 12:46 AM
pls share the output of
1. show stack-power
2. show environment power
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide