Priority Queuing on ATM subinterfaces ????

[gserghiou]

Hi All,

I am trying to configure priority queuing on my ATM subinterfaces.

I specify the priority queue to be an access list.

i then create my access list and specify the traffic to be prioritised.

I know i can configure it on serial int and fastethernet interfaces, but when i try to configure it on the ATM subinterface, i get the

%command not recognized

Is it possible to configure PQ on ATM subinterfaces and if so what is the command please.

[smahbub]

In Cisco IOS Release 12.0(25)S and Release 12.3(7)XI, and later releases, the priority command no longer allows you to specify a priority rate in kbps or as a percentage of the available bandwidth.Please check the below link for more information : http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_chapter09186a008038528d.html