Hello,
I have a contractor doing some work for me and he needs to see a few of my access switches.
I set him up with a username with privilege 5 and used a rotary group to allow him direct login to enable mode on a specific port.
Problem is when I tested, a sh run is not showing me any of the running config.
Am I doing something wrong?
2 different switches.
both are 3560x running 15.2(1)E2
commands available to level 5
(output from admin login level 15)
#sh run | inc privilege
privilege exec level 5 show running-config
privilege exec level 5 show logging
(output under his login)
#sh run
Building configuration...
Current configuration : 115 bytes
!
! Last configuration change at 21:29:01 CDT Tue May 31 2011
!
boot-start-marker
boot-end-marker
!
!
!
!
!
!
end
#sh pri
Current privilege level is 5
Thanks,
D
