About zietgiestt

zietgiestt · 10-24-2025

Hello,I have a contractor doing some work for me and he needs to see a few of my access switches.I set him up with a username with privilege 5 and used a rotary group to allow him direct login to enable mode on a specific port.Problem is when I teste...

zietgiestt · 08-27-2025

Hello,ASA HA failover pair running 9.16482ASDM v. 7.20(2)secure client 5.0 updating to 5.1.10 w/ umbrella modI am rolling out the umbrella mod to secure client for roaming umbrella coverage off net due to an incident that happened recently.I was goin...

zietgiestt · 08-25-2025

Hello,trying to figure out if I can add a module to cisco secure client...specifically the umbrella module.Or do I have to do a whole redeployment with the module added at install?If so, can I do this from my ASA? Just upload a new secure client pack...

zietgiestt · 08-19-2025

Hello,ASA 5516x, v 9.16(4)82 HA pairI'm unfamiliar with rest-api so I'm a little nervous about the unknown...I need to install rest-api to start monitoring and collecting logs (for now) for a new siem we are going to start using.Can't find anywhere t...

allow policy & A/D user · 07-22-2025

Hello,I created a new policy to block all generative AI except a couple sites that I allow.In the policy, I allow by identities and add active directory users so they can visit the sites. One of these users tested it and was able to reach the site no...

zietgiestt · 10-27-2025

Thanks so much. This is perfect!

zietgiestt · 10-24-2025

Hello,I have a contractor doing some work for me and he needs to see a few of my access switches.I set him up with a username with privilege 5 and used a rotary group to allow him direct login to enable mode on a specific port.Problem is when I teste...

zietgiestt · 08-27-2025

I just went ahead and removed the dual trustpoint from my outside interface, deleted it from identity certs and created a new one using the same valid wildcard cert. my trustpoints look normal now with only a single cert associated to it, but I'm sti...

zietgiestt · 08-20-2025

Good to know. so I installed and enabled rest-api on my active first and then did the standby. Now, entering config mode, my standby is telling me:**** WARNING ****Configuration Replication is NOT performed from Standby unit to Active unit.Configurat...

zietgiestt · 08-06-2024

Thank yo Roman, That is what I thought, just wanted confirmation.

Member Since	‎10-23-2017 08:27 AM
Date Last Visited	‎11-04-2025 03:11 PM
Posts	37
Total Helpful Votes Received	3

User Statistics

User Activity

privilege level command output

secure client vpn no longer trusted

secure client and umbrella module

ASA rest-api install

allow policy & A/D user

Re: privilege level command output

Privilege lever command output???

Re: secure client vpn no longer trusted

Re: ASA rest-api install

Re: Downloading an old amp connector