Hello gentlemen,
I have a problem in my topology, one at a time about if there is no traffic on the vlan, router R2 fails to ping the ip of the remote end svi, issu cause disorders seen everything so normalizes after I ping from (Vlan10)-R1 to ip in svi R2 - (Vlan10). when the problem another vlan trunk occurs at the same link with the switching hub continues normally. the arp table set out their macs and addresses. In troubleshooting at layer 2 and not detected any problems. Someone already I witness such a problem?
I am using switch module in any senario model HWIC-4ESW.
