cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3910
Views
0
Helpful
3
Replies

problem with monitor sess N5K

antilope1
Level 1
Level 1

Hi everybody, 

 

I have configured a monitor session on a Nexus5K and the result is: 

Nx5k_1# sh monitor sess all
   session 1
---------------
type              : local
state             : down (No operational src/dst)
source intf       : 
    rx            : Po110         
    tx            : Po110         
    both          : Po110         
source VLANs      : 
    rx            : 
source VSANs      : 
    rx            : 
destination ports : Eth1/6        

Legend: f = forwarding enabled, l = learning enabled

 

Does anybody know why it is not running? What means "No operational src/dst)"?

Configuration of destination interface: 

interface Ethernet1/6
  switchport monitor

 

Thank you very much!!!!

1 Accepted Solution

Accepted Solutions

Hello,

 

Is both source Po110 and destination porte1/6 up? can you check the status of them.

If yes, can you please try appliying the same configuration for span once again?

 

Thanks

Madhu

View solution in original post

3 Replies 3

Hello,

 

Is both source Po110 and destination porte1/6 up? can you check the status of them.

If yes, can you please try appliying the same configuration for span once again?

 

Thanks

Madhu

Hello Madhukrishnan, 

 

Yes, finally I found what was happening.... It was just the destination interface was not up because of the sfp... but when I configured it right (speed), interface got up and status came to a correct state. I forgot to explain what was happening and that now it is solved. 

You were right about if it was the interface status... it was! 

Thank you very much!! 

Glad to hear !!!