02-19-2014 01:03 AM - edited 03-07-2019 06:17 PM
rommon 2 > reset
c2851 platform with 1048576 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Upgrade ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
open(): Open Error = -13
loadprog: error - on file open
boot: cannot load "flash:c2800nm-adventerprisek9-mz.124-15.T14.bin"
c2851 platform with 1048576 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Upgrade ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0x32b0904
Self decompressing the image : ################################################################################################################################################################################################################################################################################################## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0003E9 0X00474800 C2851 Mainboard
0004F8 0X00753000 Integrated Service Engine NM
0X0014B430 Onboard PVDM2 SIMM
0X00262B0A Onboard VPN
0X000021B8 Onboard USB
0004F4 0X00016804 Virtual Private Network (VPN) Module
0X002C29F0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X01461AE6
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 22Mb.
Using 2 percent iomem. [22Mb/1024Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(15)T17, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Tue 24-Jan-12 07:41 by prod_rel_team
Image text-base: 0x400AFA38, data-base: 0x439EF1F0
System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2009 by cisco Systems, Inc.
Initializing memory for ECC
....
*** Level 2 Watch Dog Timeout ***ÿ
System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2009 by cisco Systems, Inc.
Initializing memory for ECC
....
c2851 platform with 1048576 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
(The router reboots and the process start over again)
02-19-2014 01:07 AM
*** Level 2 Watch Dog Timeout ***ÿ
Use a different IOS.
Make sure your router does not have any network modules installed.
02-19-2014 01:12 AM
I'll give it try and post later... Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide