Hi All
Can someone advise when i create and apply nested qos policy it s accept all command but doesnt display in show run , for example below class is cerated and accepted by router but in show run only show first three line's are show in runniung configs ...its been a while i have done all this so need little help...thanks
class CM-QOS-ALL-AF2
set cos 3
bandwidth percent 20
random-detect dscp-based
random-detect dscp af21 334 417 10
random-detect dscp af22 292 417 10
random-detect dscp af23 251 417 10
queue-limit 417
Class-map: CM-QOS-ALL-AF2 (match-any)
24249 packets, 1739536 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp cs2 (16)
18882 packets, 1286638 bytes
5 minute rate 0 bps
Match: ip dscp af21 (18)
0 packets, 0 bytes
5 minute rate 0 bps
Match: ip dscp af22 (20)
0 packets, 0 bytes
5 minute rate 0 bps
Match: ip dscp af23 (22)
5367 packets, 452898 bytes
5 minute rate 0 bps
QoS Set
cos 3
Packets marked 24249
Queueing
Output Queue: Conversation 268
Bandwidth 20 (%)
Bandwidth 100000 (kbps) Max Threshold 417 (packets)
(pkts matched/bytes matched) 0/0
(depth/total drops/no-buffer drops) 0/0/0