10-15-2021 06:11 AM
hello,
I need to configure QOS on a cisco 9200. here is the configuration.
==============
class-map match-all JABBER_VO
match access-group name ACL_JABBER_VO
class-map match-all JABBER_VI
match access-group name ACL_JABBER_VI
class-map match-all JABBER_SI
match access-group name ACL_JABBER_SI
class-map match-all VOICE
match ip dscp ef
policy-map QUALITY
class VOICE
set ip dscp ef
police 128000 8000 conform-action transmit exceed-action set-qos-transmit 1
class JABBER_VO
set ip dscp ef
police 128000 8000 conform-action transmit exceed-action set-qos-transmit 1
class JABBER_VI
set ip dscp af41
police 30000000 256000 conform-action transmit exceed-action set-qos-transmit 1
class JABBER_SI
set ip dscp cs3
class class-default
set ip dscp default
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#service-policy input QUALITY
Switch(config-if)#
*Oct 8 10:08:34.976: %FMANRP_QOS-3-MARKDOWNCHECK: Only markdown with a table-map is supported.
I have the following message : %FMANRP_QOS-3-MARKDOWNCHECK: Only markdown with a table-map is supported.
I need configure Table-map,
Who can help me to configure table-map ?
regards
10-15-2021 07:39 AM
%FMANRP_QOS-3-MARKDOWNCHECK : Only markdown with a table-map is supported.
Explanation | Error occured while performing exceed action check on the policy attached |
Recommended Action | Copy the error message exactly as it appears on the console or in the system log. Perform a search of the Bug Toolkit (https://bst.cloudapps.cisco.com/bugsearch/). If you still require assistance, open a case with the Technical Assistance Center via the Internet (https://mycase.cloudapps.cisco.com/case), or contact your Cisco technical support representative and provide the representative with the gathered information. |
10-15-2021 07:48 AM
Common QoS error messages on Catalyst 3850 switches - Cisco
Example:
Policy-map my-policy
class voip_signal
set dscp cs2
police cir 32000 bc 8000
conform-action transmit
exceed-action set-dscp-transmit cs3
Restriction(s):
Workaround:
table-map CS2toCS3
map from 24 to 16
default copy
policy-map my-policy
class voip_signal
set dscp cs2
police cir 32000 bc 8000
conform-action transmit
exceed-action set-dscp-transmit default dscp table CS2toCS3
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide