QoS Preservation of markings between two end systems
I have a requirement to preserve markings end to end across a network utilising 3750X switches, I am marking the packets without a problem, but due to the rewriting function the marking is being overwritten by ther COS-->DSCP maps.
To simplify the scenario I have set up a test environment (see Diagram) and am using ICMP as a simple test
using ICMP to test with
Both 3750 have 12.2(35)SE5
mls qos rewrite ip dscp
ip access-list extended ICMP
permit icmp any any
match access-group name ICMP
set dscp 46
switchport mode access
swicthport access vlan 100
mls qos vlan-based
ip address x.x.x.x
service-policy input TEST
I have used wireshark to verify that the packets are being marked, with the' mls qos rewrite ip dscp' they are, without rewriting does not occur.
Moving my sniffer to the 3750-2 I am monitoring the Layer3 connection (marking preserved), however on the layer 2 trunk the marking has been reset to 0 , if I remove the 'mls qos rewrite ip dscp' from 3750-2 then I see the marking on the layer 2 trunk, however I am then unable to remark anything generated on this switch. I believe with the 'mls qos rewrite ip dscp' enabled the L3 to L2 transistion removes the IP DSCP sets the COS to 0 and themnthe COS to DSCP mapping ensures the DSCP is set back to 0.
I have tried implementing additional marking policies on 3750-2 but to no avail.
What I need is assistance ensuring that that a frame / packet marked in 3750-1 can keep it's marking to the end system over layer 3 and a layer 2 trunk. The only place I wan t the marking to be stripped off is when the dot1q tag is removed as it goes through an access port.
Hi, I have different questions about tunnels management. 1) Imagine that you have 2 router (A,B) with a GRE Tunnel, but inside you have also 2 different routers o firewall with a vpn connection (image1 attached). Which would be the n...
Hello!I make syslogcollector + RESTAPI for collect syslog messages.It have next iterested features:1. Can recognise header from Cisco/Moxa and more devices and write it in dedicated field2. Have API for integrated with other tools3. Work with Mongodb4. We...
Cisco Digital Network Architecture Center Modules (Design Module)Part.3In this article, we are going to talk about the Cisco Digital Network Architecture Center design Module.Cisco DNA Center gives us the flexibility and scalability to configure mult...
Cisco 2509-RJ freezes during start-up I bought some Cisco 2509-RJ terminal server to work on my labs and was working fine. Today I turned it on and half way through starting up it seems to freeze. I can only find one instance of this happing to ...
Cisco Digital Network Architecture Center Modules(Design Module)Part.2In this article, we are going to talk about the Cisco Digital Network Architecture Center design Module. Cisco DNA Center gives us the flexibility and availability to con...