cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
345
Views
0
Helpful
2
Replies

Question on passive serial sub interface EIGRP

mahesh18
Level 6
Level 6

                   Hi Everyone,

I know how passive interface default works in EIGRP.

I need to confirm below say we have

se0/0/0

no ip address

se0/0/0.10

ip address 192.168.50.1 x.x.x.x

Router eigrp 100

passive interface default

no passive interface se0/0/0

I do not have device to test this so need to confirm if i also need command

no passive interface se0/0/0.10 or not?

Regards

Mahesh

1 Accepted Solution

Accepted Solutions

Richard Burts
Hall of Fame
Hall of Fame

Mahesh

I do not have any device that would allow me to test this either. But I believe that you need to specify the subinterface and not just the physical interface.

HTH

Rick

HTH

Rick

View solution in original post

2 Replies 2

Richard Burts
Hall of Fame
Hall of Fame

Mahesh

I do not have any device that would allow me to test this either. But I believe that you need to specify the subinterface and not just the physical interface.

HTH

Rick

HTH

Rick

Hi Rick,

I trust you fully.

Many thanks for confirmation.

Best regards

Mahesh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: