"dsl operating-mode auto" Not Supported On 15.1(4)M5

[Elie Bassil]

Hello,

I am moving from 877 12.4(15) to 887VA-M 15.1(4)M5. In the old configuration I have:

interface ATM0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

!

In the new router/IOS, the command "dsl operating-mode...."  isn't supported under interface ATM0. Was wondering if the syntax changed or..?

10x,

[acampbell · Accepted solution]

Hi,

some of the config for the 887 has moved in to the vdsl controller

!

controller vdsl 0

operating mode auto

!

This link will help you

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html#wp1189826

Regards,
Alex.
Please rate useful posts.

[Elie Bassil]

Thanks acampbell !