Hello,
I am moving from 877 12.4(15) to 887VA-M 15.1(4)M5. In the old configuration I have:
interface ATM0
no ip address
no atm ilmi-keepalive
dsl operating-mode auto
!
In the new router/IOS, the command "dsl operating-mode...." isn't supported under interface ATM0. Was wondering if the syntax changed or..?
10x,
Solved! Go to Solution.
Hi,
some of the config for the 887 has moved in to the vdsl controller
!
controller vdsl 0
operating mode auto
!
This link will help you
Regards,
Alex.
Please rate useful posts.
Hi,
some of the config for the 887 has moved in to the vdsl controller
!
controller vdsl 0
operating mode auto
!
This link will help you
Regards,
Alex.
Please rate useful posts.
Thanks acampbell !