"ip policy route-map " command not exists

[abhishekpal]

Hi

Purchased a new Catalyst 9606 Series 6 Slot Chasis with C9600-SUP-2 Card running Cisco IOS Software [Cupertino], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 17.7.1, RELEASE SOFTWARE (fc5) .

I am not sure what I am doing wrong - but the command "ip policy route-map" command to get the PBR up and running is not there under the L3 interface.

Can anybody help on this ?

Here is my configuration -

!
interface FiftyGigE2/0/23
no switchport
ip address 192.168.0.1 255.255.255.252

!

ip access-list extended 125
10 permit ip any any

!

route-map TEST permit 10
match ip address 125
set ip next-hop 192.168.2.1

Thanks in advance.

Abhishek 

[balaji.bandi]

Looks for me Bug, last i was tested on IOS XE PBR was 16.12.X code 

what is output - IP policy ? (under interface)

[abhishekpal]

Hi

No output. The command doesn't exists under L3 Interface , it generates " Invalid Input Detected.."

Abhishek

[Georg Pauwen]

Hello,

--> set ip next-hop 192.168.2.1

Is the next hop directly connected and reachable ?

[abhishekpal]

Hi

Yes , it was not previously up- but I have connected the ports ( 2 ports in consideration - input & output)  and assigned IP address to the oppsite end port- they started pinging. But no luck with the "ip policy route-map next-hop " command.

Abhishek

[abhishekpal]

Hi All 

Please refer to a screenshot of Cisco Document , which I fished out from Internet.

Can anybody answer - what is this  ? Why it is applicable for a L3 Switch ?

Abhishek 

[balaji.bandi]

show module and see if you running sup-2, then that will not work for you.

[abhishekpal]

Hi

Yes, that is not available. Cisco TAC confirmed that will be added after 31st March,2023 in a new software release. 

Abhishek

[balaji.bandi]

sure and thank you for your feedback.