cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2603
Views
0
Helpful
1
Replies

"show controllers ethernet-controller" on 4506E with IOS-XE not available

Dirk Feldhaus
Level 1
Level 1

Hello,

we're trying to troubleshoot a Performance Problem in an Environment with an 4506E with IOS-XE. While checking Interface statistics we noticed that the command "show controllers ethernet-controller" is not available.

I'm looking for details on an packet statistics like number of Frames with (multiple) collisions, number of Frames with different sizes , etc..

On other platforms, i.e. 2960s with IOS 12.2 these statistics are provided by that command:

     Transmit GigabitEthernet1/0/50           Receive
   2249530963 Bytes                       2574239256 Bytes
      1967919 Unicast frames                13775968 Unicast frames
     43304607 Multicast frames            2515297691 Multicast frames
       161587 Broadcast frames             502643931 Broadcast frames
            0 Too old frames              2901962856 Unicast bytes
            0 Deferred frames             1585347665 Multicast bytes
            0 MTU exceeded frames         3173099293 Broadcast bytes
            0 1 collision frames                   0 Alignment errors
            0 2 collision frames                   0 FCS errors
            0 3 collision frames                   0 Oversize frames
            0 4 collision frames                   0 Undersize frames
            0 5 collision frames                   0 Collision fragments
            0 6 collision frames
            0 7 collision frames             2432623 Minimum size frames
            0 8 collision frames          1834324393 65 to 127 byte frames
            0 9 collision frames            24556290 128 to 255 byte frames
            0 10 collision frames           28496988 256 to 511 byte frames
            0 11 collision frames            1411568 512 to 1023 byte frames
            0 12 collision frames         1140487398 1024 to 1518 byte frames
            0 13 collision frames                  0 Overrun frames
            0 14 collision frames                  0 Pause frames
            0 15 collision frames
            0 Excessive collisions                 0 Symbol error frames
            0 Late collisions                      0 Invalid frames, too large
            0 VLAN discard frames               8330 Valid frames, too large
            0 Excess defer frames                  0 Invalid frames, too small
      2339694 64 byte frames                       0 Valid frames, too small
       376060 127 byte frames
      4708637 255 byte frames                      0 Too old frames
      3560540 511 byte frames                      0 Valid oversize frames
         9451 1023 byte frames                     0 System FCS error frames
     34416250 1518 byte frames                     0 RxPortFifoFull drop frame
        23481 Too large frames
            0 Good (1 coll) frames
            0 Good (>1 coll) frames

 

 Any idea how to get this kind of information?

Appreciate any comments or help.

 

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

The command "sh controll e <PORT>" is not available on the 4500/6500 series.  

 

For the 4500, can you try the command "sh interface <BLAH> counters".  There are a number of sub-options, such as "errors" and "details" which can be helpful.