Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

Hi,How can I see on a Catalyst 2960S, sw version 15.0(2)SE6 which LLDP TLVs are configured? At the moment the troubleshooting options regarding LLDP seem to be a little bit limited. Even "show running-config" doesn´t show any configured LLDP-MED TLV´...

mose by Level 1
  • 326 Views
  • 0 replies
  • 0 Helpful votes

I've been trying to upgrade out 7k to 5.1.3 via ISSU and keep running into failures.  Does anyone know where I can look up the error code listed below?Notifying services about system upgrade.[#                   ]   0% -- FAIL. Return code 0x40B30029...

ewood2624 by Level 5
  • 4869 Views
  • 3 replies
  • 0 Helpful votes

So I relatively new, and I am wanting to register a deal for creating a data center (mostly switching).  I would like to take advantage of educational pricing. Is there a process that I can follow?

jscott by Level 1
  • 1681 Views
  • 1 replies
  • 0 Helpful votes

I've inherited a network from a predecessor with no documentation.  The network is incorporating VLANs for various types of users and resources.  I have done some basic work on VLANs, establishing them and configuring them on ports, but I'm very gree...

Hi, When I reload the stack (or a stack member), the LED for mode is in status "STAT". In the documentation ist says that the mode should be "STACK" to use the full bandwidth of the stack ports. Nevertheless...-> I can not find a documentation that d...

Hi I have a 2960 switch connected in my network. It is showing high CPU utilization upto 80-90%. When I checked I found that the below processes are taking the highest utilization. The image in the switch is LAN base. Can someone please advice on why...

I'm trying to install Cisco 3560CG switch using Smart InstalI based on Connectivity. 3560CG is connected to Cisco 4500x (IOS 03.06.00.E.152-2.E) in port 15.Here is the configuration:4500x:interface Vlan1 ip address 192.168.1.1 255.255.255.0vstack vla...

Jure Knez by Level 1
  • 2285 Views
  • 9 replies
  • 0 Helpful votes

Hi Everyone,We are using nexus switches in our network. Can anyone of you please let me know what is the command to check logs for specific interface. I am using #show log |i eth1/2. I am not sure is this correct but when I use this I get nothing.Ple...

Hello, I am starting to be a bit frustrated, I would need a help with setting up a router. I have cisco 2811 router connected to my modem and outside interface obtained the IP address automatically from DHCP server from my provider.My question is, wh...

Hi,I was wondering if I could get some advice regarding an issue I'm having. I'm sure it's something really trivial but it's been really bugging me to the point where I'm losing sleep. :)I'm just playing around with ESXi 5.5 and I'm trying to route t...

maguro403 by Level 1
  • 1862 Views
  • 8 replies
  • 0 Helpful votes