Radius authentication failed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-17-2020 07:56 PM
Hi guys
I am trying to configure authentication login with radius server. This configuration is working fine with 2960, 3860, but something wrong with my 4507
- From 2960, 3860: user privilege 15 and privilege 1 are authenticated right, i can see everything by "debug radius; terminal monitor"
- From 4507: user privilege 15 is authenticated fine, but user privilege 1 is not authenticated, and the crazy thing is that i can not see log with these commands "debug radius; terminal monitor" even user is authenticated or not.
I post my brief configuration here by image, because my older posts are marked as spam (don't know why)
- Labels:
-
Catalyst 4000
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2020 12:56 AM
- What's in the radius server's logs for these particular attempts, also note if there is any difference in the server's logs for the switch-models were the authentication is working properly.
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2020 02:53 PM
Hi Ha,
Just curios, I do not see a local user of privilege level 1. That means, it will be checked only on the radius server. Is that correct?
Meheretab
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2020 08:12 PM
