10-08-2021 04:33 AM
Dear Support,
I am configuring an access switch with main fiber link connection to Aggregation/core switch and a second fiber link connection to the same Aggregation/core switch.
How should the access switch and aggregation/core switch be configured to allow two connection from access switch to core switch?
Thanks guys!
Isaac.
Solved! Go to Solution.
10-08-2021 04:50 AM
Is your Agreegation switch part of VSS or VSL - Depends on requirement.
If this Pure Layer 2 - LACP Port-channel will be good
Access swictch switch 1 (uplink)-- Port-channel X------Aggigation switch 1
Access swictch switch 2 (uplink)-- Port-channel X --------Aggigation switch 2
10-08-2021 05:25 AM
If they are not part of SVL (most deployment we have was, Layer3 deployment using OSPF or EIGRP) Load balance.
In that Case Access switch need to configure Layer 3 p2p interface and IGP will take care LB.
hope this make sense ? if that answers your question ?
10-08-2021 04:50 AM
Is your Agreegation switch part of VSS or VSL - Depends on requirement.
If this Pure Layer 2 - LACP Port-channel will be good
Access swictch switch 1 (uplink)-- Port-channel X------Aggigation switch 1
Access swictch switch 2 (uplink)-- Port-channel X --------Aggigation switch 2
10-08-2021 05:05 AM
BB,
Thanks for your answer.
The Agg switch is in SVL,so your suggestion will work!
But what if the switches where not in SVL but logically separate,would the approach be different?
Regards,
Isaac.
10-08-2021 05:25 AM
If they are not part of SVL (most deployment we have was, Layer3 deployment using OSPF or EIGRP) Load balance.
In that Case Access switch need to configure Layer 3 p2p interface and IGP will take care LB.
hope this make sense ? if that answers your question ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide