Remote Access VPN Client cannot ping network connected via the outside interface

[lmanavalan]

Hi

I have an ASA ASDM 7.3 connected to my core Switch and I configured the remote access spilt-tunnel VPN. it works fine

The VPN client is able to connect and when I check the route details I can see all my office network.

My VPN client can access the network connected to the inside interface of the firewall but I have few network (10.1.1.0/24) which is connected to the core switch so firewall can reach those network via the outside interface.

My issue the VPN client is not able to reach those network (10.1.1.0/24). The show route on the firewall for the (10.1.1.0/24) is pointing to outside interface and also my VPN Client IP also point to outside interface.

What need to be configured to make use the VPN client can access the 10.1.1.0/24

Thanks

Logesh

[Yashas Bhadoria]

Can you check the following :

1.NAT exemption rule for the VPN clients

2. Please check that if the ACL is not dropping the clients.

Please check the following link also;

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/100918-asa-sslvpn-00.html

[lmanavalan]

Hi

I have configured NAT exempt. To explain my network issue I have attached a diagram.

Regards

Logesh