RESET CISCO VG202

[SAMUEL HUERGA]

I would like to know how to factory reset a Cisco VG202 without having the password. When I access the computer's cmd, I enter the "enable" command, but from there it asks me for a password.

I would like to know if there is any command or something that I can do.

Thanks!!

[Reza Sharifi]

Have a look at this post:

https://community.cisco.com/t5/networking-knowledge-base/password-recovery/ta-p/3123097

HTH

[SAMUEL HUERGA]

when I press the "breaf" key I get this and I still can't access it.

Readonly ROMMON initialized
program load complete, entry point: 0x80020000, size: 0x122f0cc
Self decompressing the image : ################################################# ################################################################################ ################################################## [OK]

Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706

[Reza Sharifi]

How about control and break?

Try different combinations and see which one works.

HTH