02-21-2005 09:55 AM - edited 03-05-2019 11:26 AM
I've recently purchased 2 1538M hubs, but the seller did not have the IP, or other items needed to use the Configmaker tool to get them setup.
I've tried a crossover cable and no luck either. Is there a hardware way to set these to default and get them setup correctly?
Thanks in advance.
A Perez - Rivernet Communications
02-21-2005 11:03 AM
From the quick start guide:
HTH
Steve
--Please rate if helpful.
02-21-2005 02:05 PM
Thanks for the help, but I've gone through this page already.
There's no "reset button" inside the hub itself??
02-21-2005 04:39 PM
Use the link above to get connected, then this link to enter "Diagnostic Console" and reset the hub to factory defaults.
Here's the link to entire users manual, you'll need to this reconfigure your hub.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide