07-12-2015 02:25 PM - edited 03-08-2019 12:56 AM
Hello All,
I am following the procedure to upgrade Nx-OS on nexus 5000 & 7000 switches as
given in Cisco documentation.
My doubt is, if after upgrading the switches(one of them or both in a cluster) there is a need to revert back to the old OS/config,
how can this be done?
Will changing the boot statement to the old Nx-OS be viable? How does this work in case of nexus, as fex's are attached.
Thanks in advance.
Solved! Go to Solution.
07-12-2015 02:32 PM
Hi,
Once you upgrade to a newer version or downgrade to an older version, the 5000 or 7000 switch will upgrade or downgrade the FEXs. Think of a FEX being a blade connected to the chassis. When you upgrade or downgrade the main switch, blade will be upgraded or downgraded as well.
HTH
07-12-2015 02:32 PM
Hi,
Once you upgrade to a newer version or downgrade to an older version, the 5000 or 7000 switch will upgrade or downgrade the FEXs. Think of a FEX being a blade connected to the chassis. When you upgrade or downgrade the main switch, blade will be upgraded or downgraded as well.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: