12-01-2013 08:18 PM - edited 03-07-2019 04:52 PM
Some one did mention the access list is 10 and i have a ip nat inside source list 1, but this is working for our internet router fine, I just need to add our wireless controller to connect directly to the switch so it does not touch our network.
Thanks
Mike
Here is my current config.
!
control-plane
!
end
12-02-2013 05:51 AM
Mike
It's not clear exactly what you are trying to do and there are few things in your config that are confusing ie.
you have two links, one goes to your ISP and the other to your firewall. You have "ip nat outside" on your ISP connection. So does traffic not go via the firewall ?
In terms of your wireless, if you are trying to NAT the 192.168.253.x addresses then your NAT statement is wrong ie. -
ip nat inside source list 1 interface GigabitEthernet0/0 overload
you are referencing acl 1 but your acl in the config is acl 10 so you should remove the above and replace it with -
no ip nat inside soure list 1 interface gi0/0 overload
ip nat inside source list 10 interface gi0/0 overload
or if you want just change the acl from 10 to 1. Up to you.
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide