My Setup is as follows
Draytek Router
192.168.1.254
VLAN 10, 20, 30, 40, 50
Cisco SG300 Layer 2 (Switch 1)
Draytek connected to port 14, which is a trunk port with access to all the VLANS (1up, 20T, 30T, 40T, 50T)
2nd SG300 Layer 2 (Switch 2)
Connects to Port 17 on the above switch via port 24
3rd SG300 Layer2 (Switch 3)
Connects to Port 18 on Switch 1 via port 24
Each switch has Port 24 set up to as a trunk port on Every VLAN.
If I am connected to a port on Switch 2 the VLAN traffic is passed, but if I connect via switch 3 then I cannot reach the VLAN.
I have been looking at this for two days now and I cannot see why this would be the case, other than switch 3 cannot see the router. Although I can do the usual things like ping the router etc
Any ideas appreciated.
