I have cisco 9500 switch.
I have 2 interface for communicate with outside.
I have 5 VLANs (VLAN10, VLAN20, VLAN30, VLAN40 and VLAN50)
VLAN10 ip address : 10.10.10.1/24
VLAN20 ip address : 20.20.20.1/24
VLAN30 ip address : 30.30.30.1/24
VLAN40 ip address : 40.40.40.1/24
VLAN50 ip address : 50.50.50.1/24
2: wan interface is x.x.x.x and gateway is a.a.a.a
wan interface is y.y.y.y and gateway is b.b.b.b
My requrement is
VLAN10,VLAN20,VLAN30 and VLAN50 traffic will goes through wan interface x.x.x.x
and only VLAN50 traffic will goes through wan interface y.y.y.y
but same time my default route will be in routing table that is
0.0.0.0 0.0.0.0 x.x.x.x
how i will route the traffic