I have a this switch and I'm trying to setup a very simple routing command to send all traffic to the next hop. The basic configuration I have done is:
- IP Routing
- IP route 0.0.0.0 192.168.11.1
- Vlan 1 address 172.16.104.1/24
- All switch ports on Vlan 1
- No switchport
- address: 192.168.11.104/24
From the switch I can ping 184.108.40.206 just fine
From a PC connected I can ping
But can't ping
- Or the internet
Running tracert from the PC I can see it reach 172.16.104.1 as the first hop but after that everything else fails.
I don't have access to the 192.168.11.1 device (corporate rules). I do not have any routing protocols or NAT setup. I feel like I'm missing on simple thing but not sure what it is.