cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1136
Views
0
Helpful
2
Replies
Highlighted

Routing table is not updating

Hi,

I am using Cisco 2911 & IOS version is 15.1. My problem is that after some days (e.g. 15-20 days), the routing table suddenly stops updating & then I have to enter the default route again to make it up. I am using Track 1 to track default route here. After primary link goes down, the Track is also going down but after coming the primary link up, the track is not coming up. So, I have to add the default route again to make it up. Why it is happening? Please suggest.

-Ballu.

2 REPLIES 2
Highlighted
Advisor

Hi,

how are you doing your IP SLA for tracking, post your config:

you should either use source-interface or put a host route to the tracked IP or use local PBR for the IP SLA

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Highlighted
Beginner

Hello Balbeer

Although if you posted an example of your configuration it would be easier to help you out , but let me try to see if I got you right.

Lets assume that you have the following configuration

ip route 0.0.0.0 0.0.0.0 1.1.1.1 track 1 " main route"

ip route 0.0.0.0 0.0.0.0 2.2.2.2 track 2 " Backup route"

and lets say track 1 is pointing to 8.8.8.8

while track 2 is pointing to 4.2.2.2

than you need to add the following

IP route 8.8.8.8 255.255.255.255  1.1.1.1

IP route 4.2.2.2 255.255.255.255  2.2.2.2

please refer to the following link for more infromation

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

Hope it will help

Ahmed Sonba

Content for Community-Ad