I am trying to configure a SPAN from two source ports to a single destination port. SPAN source 1 is an RSPAN session from a remote switch to a local destination port. I was able to successfully configure this. SPAN source 2 is a port on the local switch and I'm trying to configure to the same destination port as SPAN 1. I don't see anything in the configuration guide stating that this is not supported, but I receive message 'Cannot add VLANs as source for session 2 - a RSPAN Destination session' when I attempt to configure the local source SPAN. If this is not allowed, is there another way for me to achieve this?
Thanks! Glenn
