10-12-2011 12:28 PM - edited 03-07-2019 02:46 AM
I was attempting to configure an RSPAN session from one of my clients access layer switches. here is what I am getting when i get the error that I receive
tbh7#conf t
Enter configuration commands, one per line. End with CNTL/Z.
tbh7(config)#monitor session 1 destination remote vlan 25
^
% Invalid input detected at '^' marker.
tbh7(config)#
The version is
tbh7#sho ver
Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Sat 07-Aug-10 23:21 by prod_rel_team
Image text-base: 0x00003000, data-base: 0x01B00000
ROM: Bootstrap program is Alpha board boot loader
BOOTLDR: C2960S Boot Loader (C2960S-HBOOT-M) Version 12.2(53r)SE, RELEASE SOFTWARE (fc3)
tbh7 uptime is 14 weeks, 2 days, 1 hour, 15 minutes
System returned to ROM by power-on
System restarted at 13:57:28 EST Mon Jul 4 2011
System image file is "flash:/c2960s-universalk9-mz.122-55.SE.bin"
Is the code on this not capable of RSPAN?
Thx
Kevin
Solved! Go to Solution.
10-12-2011 12:34 PM
Do you have LAN base IOS license installed?
To use RSPAN, the switch must be running the LAN Base image.
HTH
10-12-2011 12:34 PM
Do you have LAN base IOS license installed?
To use RSPAN, the switch must be running the LAN Base image.
HTH
10-12-2011 01:13 PM
Thanks for the quick resonse, Reza!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: