In a shared Ethernet environment, runt frames are almost always caused by collisions. If the collision rate is high, refer to the problem of excessive collisions, earlier in this table. If runt frames occur when collisions are not high or when in a switched Ethernet environment, then they are the result of underruns or bad software on a network interface card. Use a protocol analyzer to try to determine the source address of the runt frames.
How do i must interprete this?
In wireless collisions are possible so this is 'OK'?
Do we have a problem with the SW running on the AP (all cisco but different types)
Since 2008, the ASR 1000 platforms have dramatically changed the WAN edge router’s capabilities. With its very own QuantumFlow Processor (QFP) innovation, the data plane was powered to offer advanced scalable services along with high performance. Fast for...
Traditionally Cisco has used several different methods for storing passwords and keys in IOS. The older methods are Type 5 (MD5 hash) & Type7 (Vigenere obfuscation). We enabled Type 7 encryption with the CLI service password-encryption...
AI spoofing detection is a feature in AI Endpoint Analytics released in Cisco DNA Center v18.104.22.168, that identifies endp...
Como parte de mi preparacion para el ENARSI he estado haciendo una serie de videos para que se me quede mas grabado todo, en el siguiente link encontraran una liga con los mecanismos de asignacion de direccion IPV6 a Hosts https://youtube...
So you have the DNA Center racked and stacked in your data centre, and you are thinking what next?
To get instant value from your DNA Center, you should next discover and add your network devices to it. In this video, we will take you through the ...