s72033-advipservicesk9_wan-mz.122-33.SRA2.bin

[santanumandaladn]

I have a Cisco 7609 router.

I am using IOS 122-33.SRA2.bin[Mentioned in subject]  with SUP 720 card[model WS-SUP720-3B].

When I am inserting a SUP 720 card[Model WS-SUP720-3BXL] with this IOS and booting it from ROMMON mode then- It shows downloading image, Self decompressing image and then again revert back to ROMMON mode.

Please suggest!!

Santanu

[andtoth]

Hi Santanu,

Was this working before? Are you seeing this with other images as well?

What specific error messages do you receive? Please paste the relevant log messages which are printed when the sup is going back to rommon.

Thanks,

Andras

[smogra]

Does this setup ever worked before?

And if you give "boot" on rommon prompt, does the router boot properly after that?

Please check

1. whether the image is compatible with the hardware on which you are trying to load.

2. has the bootvariable set properly or not

3. config register values are 0x2102 or not.

4. manual boot should not be set to "yes".

Cheers

Sweta

Please rate useful posts.

[Somasundaram Jayaraman]

Hi,

The image 122-33.SRA2, is compatible with ws-sup720-3BXL.

All this images require aminimum DRAM memory of 512 MB and flash size of 128 MB.

		IP SERVICES SSH s72033-ipservicesk9_wan-mz.122-33.SRA2.bin Release Date: 06/DEC/2006 Size: 81187.48 KB (83135972 bytes) Minimum Memory:                                                                                                                                                                      DRAM:512MB                                                                                                                                                                                                                                                     Flash:128MB

Can you check whether this supervisor meets this memory requirements.

It could be possible the image might got corrupted.

Did you verified the image for errors after copying it to the memory device.

switch# verify /md5 :image.bin

Check whether the size of the image is correct by comparing it in cisco site.

Link for downloading the image for SRA series is given below

http://www.cisco.com/cisco/software/release.html?mdfid=282201754&flowid=1989&softwareid=280805680&release=12.2.33-SRA2&rellifecycle=ED&relind=AVAILABLE&reltype=all

Hope this helps

Cheers

Somu

Rate helpful answers