03-02-2020 06:07 AM
Dear Community Members,
I am using Cisco Layer 3 Switch Image on GNS3 and those two commands are not available, I searched on Internet but found nothing about the issue.
1. sdm prefer
2. macro name
this is the version I am using
vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Version 15.2(4.0.55)E
Can any one kindly show some explanation, Appreciate your answers...
My best regards
Solved! Go to Solution.
03-02-2020 06:55 AM
Hello,
I run the same image, the commands are not on there. Keep in mind that this is a virtualized image, not a real switch. They did not integrate the complete set of IOS commands in that image...
03-02-2020 06:55 AM
Hello,
I run the same image, the commands are not on there. Keep in mind that this is a virtualized image, not a real switch. They did not integrate the complete set of IOS commands in that image...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide