08-19-2015 01:11 PM - edited 03-08-2019 01:25 AM
Hi All i just purchased 10g SR sfp for 4510 RE switch i have and unable to cdp nei to 3750x switch I have right next to it.
i verified i can cdp nei and see the switches from both ends when i plug a cat 6 between the both but when i plug my fiber in to my sfp 10g I cant and says in active.
any advice would be greatly appreciated.
08-19-2015 02:11 PM
Hi,
For 10Gig you need SFP+. If yes, are the ports in up and up mode in both switches?
sh ip int bri tex/x
HTH
08-21-2015 10:16 AM
Thanks for your reply Reza! I found out via the specs on the supervisor module that the sup 7e operating SSO has two ports disabled by default.
Limitation and Restrictions on Supervisor Engine 7-E
Please note the following:
•When you use WS-X45-SUP7-E in RPR or SSO mode, only the first two uplinks on each supervisor engine are available. The second two uplinks are unavailable.
Thanks again!
Priscilla
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: