10-16-2017 12:38 PM - edited 03-08-2019 12:23 PM
Hello I have the SG200-26 Smart Switch and when I go to add a port to a VLAN under the Port VLAN Membership tab none of the VLANs I created show up in the dialog box so there is no way for me to add them.
Solved! Go to Solution.
10-16-2017 01:32 PM
Hello,
try and reboot the SG200...
Which firmware version are you running ?
10-16-2017 12:59 PM
Hello,
in VLAN Management > Interface Settings do you have a Mode (Access or Trunk) set for the respective port (page 182 of the attached user guide) ?
10-16-2017 01:22 PM
I have tried both Access and Trunk but either way no VLANs show up in the dialog box, not even the default VLAN.
10-16-2017 01:32 PM
Hello,
try and reboot the SG200...
Which firmware version are you running ?
10-16-2017 01:57 PM
I was running 1.3.0.26 but I just upgraded to 1.3.7 then to 1.4.8 and now they show up. Thanks!
10-16-2017 02:15 PM
Firmware is usually the first thing you want to upgrade in these small business switches. Glad that you got it to work...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: