09-21-2015 08:21 AM - edited 03-08-2019 01:52 AM
Good Afternoon,
We have just purchased a new SG200-50 50-Port Gigabit Smart Switch , I`m unable to get any more than 200 mbps throughput on any of the data ports, I have tried Multiply devices on the switch
with no luck , any ideas ?, this is advertised as a Gigbit switch.
kindest regards
Adam
09-21-2015 08:43 AM
Next time you pose a question provide more details please as I can only guess at this point.
The factsheet says this switch can support 100 gbps total throughput and that it has 48 gigabit Ethernet ports. Did you set all the ports to the correct speed ("speed all 1000 full-duplex" command)? Are you using proper cables? Do the other devices support gigabit speeds?
09-24-2015 12:37 AM
Hi Blandekic,
I seem to have over come the problem with the Cisco switch , Having upgraded both the firmware and Boot Image , I am now getting approximately Mbps 900 + , many thanks for looking into the problem.
Kindest Regards
Adam
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide