Good Afternoon All,
I'm having difficulties setting up my Cisco SG300 switch with a WatchGuard XTM 26 and was wondering if I could have your assistance.....
Below is my current setup and what I am trying to achieve
Cisco SG300 Switch
- Switch in L3 mode
- x3 VLAN's configured excluding Mangement VLAN 1
- VLAN 10 - Guest Network
- VLAN 20 - Home Network
- VLAN 30 - Test Environment
- Each VLAN has its own IPv4 Interface
- VLAN 10 - 192.168.10.254
- VLAN 20 - 192.168.20.254
- VLAN 30 - 192.168.30.254
- DHCP Pools are setup on the following VLAN's
- VLAN 10 - 192.168.10.1 - 192.168.10.253
- VLAN 20 - 192.168.20.1 - 192.168.20.253
- Access Control Lists are configured to prevent each network from seeing the other
- IPv4 Routes are shown in attached photo
- Port to VLAN's are setup as follows
- GE1 - Management VLAN
- GE2 - Cable to WatchGuard's trusted interface
- GE3 - Guest VLAN 10
- GE4 - Home VLAN 20
- GE5 - Test Envirnoment VLAN 30
- GE8 - Wi-Fi AP
- Interface settings on switch
- GE1 - Trunk
- GE2 - Trunk
- GE3 - Access
- GE4 - Access
- GE5 - Access
- GE8 - Trunk (As Wi-Fi will be broadcasting more than 1 network and will require access to VLAN's
- Port to VLAN
- VLAN 10 - GE2 Tagged, GE3 Untagged, GE8 Tagged
- VLAN 20 - GE2 Tagged, GE4 Untagged, GE8 Tagged
- VLAN 30 - GE2 Tagged, GE5 Untagged, GE8 Tagged
I am trying to point all these VLAN's to next hop over to the WatchGuard which is on IP 10.0.10.254.
When I try to create a IPv4 Route of 0.0.0.0 255.255.255.0 I receive the following error "Only a directly connected router can be defined as the gateway"
Can somebody tell me where I am going wrong :S
Thanks,
Nick
