I need help.
I want to display the dBm level on a QSFP+ interface. The <show interface e10/1 transceiver detail> command display a level of 0dBm.
Software
BIOS: version 2.12.0
kickstart: version 6.2(10)
system: version 6.2(10)
BIOS compile time: 05/29/2013
kickstart image file is: bootflash:///n7000-s2-kickstart.6.2.10.bin
kickstart compile time: 10/9/2014 12:00:00 [10/17/2014 03:45:38]
system image file is: bootflash:///n7000-s2-dk9.6.2.10.bin
system compile time: 10/9/2014 12:00:00 [10/17/2014 05:39:33]
********************************************************************************************************************
DC01XSW0052-prod# sh int e10/1
Ethernet10/1 is up
admin state is up, Dedicated Interface
Belongs to Po1510
Hardware: 10000/40000 Ethernet, address: f078.16c7.3bcc (bia f078.16c7.3bcc)
Description: DC01XSW0111_e2/7
MTU 9216 bytes, BW 40000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
Port mode is trunk
full-duplex, 40 Gb/s, media type is 40G
Beacon is turned off
Auto-Negotiation is turned off
Input flow-control is off, output flow-control is off
Auto-mdix is turned off
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped 2d21h
Last clearing of "show interface" counters 2d21h
5 interface resets
Load-Interval #1: 30 seconds
30 seconds input rate 3904 bits/sec, 4 packets/sec
30 seconds output rate 32 bits/sec, 0 packets/sec
input rate 3.90 Kbps, 4 pps; output rate 32 bps, 0 pps
Load-Interval #2: 5 minute (300 seconds)
300 seconds input rate 3656 bits/sec, 3 packets/sec
300 seconds output rate 72 bits/sec, 0 packets/sec
input rate 3.66 Kbps, 3 pps; output rate 72 bps, 0 pps
RX
0 unicast packets 1662097 multicast packets 0 broadcast packets
1662097 input packets 122453908 bytes
0 jumbo packets 0 storm suppression packets
0 runts 0 giants 0 CRC/FCS 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
0 unicast packets 36348 multicast packets 0 broadcast packets
36348 output packets 4713486 bytes
0 jumbo packets
0 output error 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
*************************************************************************************************************************
Core Plugin, Ethernet Plugin
DC01XSW0052-prod# sh int e10/1 transceiver details
Ethernet10/1
transceiver is present
type is QSFP+ BiDi
name is CISCO-AVAGO
part number is AFBR-79EBPZ-CS2
revision is 01
serial number is AVM1851U3HD
nominal bitrate is 20600 MBit/sec per channel
Link length supported for 50/125um OM3 fiber is 100 m
cisco id is --
cisco extended id number is 220
cisco part number is 10-2945-02
cisco product id is QSFP-40G-SR-BD
cisco vendor id is V02
number of lanes 4
Lane Number:1 Network Lane
SFP Detail Diagnostics Information (internal calibration)
----------------------------------------------------------------------------
Current Alarms Warnings
Measurement High Low High Low
----------------------------------------------------------------------------
Temperature N/A 0.00 C 0.00 C 0.00 C 0.00 C
Voltage N/A 0.00 V 0.00 V 0.00 V 0.00 V
Current N/A 0.00 mA 0.00 mA 0.00 mA 0.00 mA
Tx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Rx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Transmit Fault Count = 0
----------------------------------------------------------------------------
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
Lane Number:2 Network Lane
SFP Detail Diagnostics Information (internal calibration)
----------------------------------------------------------------------------
Current Alarms Warnings
Measurement High Low High Low
----------------------------------------------------------------------------
Temperature N/A 0.00 C 0.00 C 0.00 C 0.00 C
Voltage N/A 0.00 V 0.00 V 0.00 V 0.00 V
Current N/A 0.00 mA 0.00 mA 0.00 mA 0.00 mA
Tx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Rx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Transmit Fault Count = 0
----------------------------------------------------------------------------
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
Lane Number:3 Network Lane
SFP Detail Diagnostics Information (internal calibration)
----------------------------------------------------------------------------
Current Alarms Warnings
Measurement High Low High Low
----------------------------------------------------------------------------
Temperature N/A 0.00 C 0.00 C 0.00 C 0.00 C
Voltage N/A 0.00 V 0.00 V 0.00 V 0.00 V
Current N/A 0.00 mA 0.00 mA 0.00 mA 0.00 mA
Tx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Rx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Transmit Fault Count = 0
----------------------------------------------------------------------------
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
Lane Number:4 Network Lane
SFP Detail Diagnostics Information (internal calibration)
----------------------------------------------------------------------------
Current Alarms Warnings
Measurement High Low High Low
----------------------------------------------------------------------------
Temperature N/A 0.00 C 0.00 C 0.00 C 0.00 C
Voltage N/A 0.00 V 0.00 V 0.00 V 0.00 V
Current N/A 0.00 mA 0.00 mA 0.00 mA 0.00 mA
Tx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Rx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
Transmit Fault Count = 0
----------------------------------------------------------------------------
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
