03-28-2018 03:49 AM - edited 03-08-2019 02:25 PM
Hey guys,
I'm studying for the CCNA and I stumbled upon something.
On Chapter 7 of Wendell Odom's CCENT/CCNA ICND1 100-105 he states some ''show'' commands.
Two of them are ''show mac address-table count'' and ''show mac address-table aging-time''.
I typed those in both Cisco 200-125 Network Simulator and Packet Tracer and got this:
Switch#show mac address-table count
^
% Invalid input detected at '^' marker.
I'll mention that the topologies are running with mac address-table populated.
Thanks!
03-28-2018 03:57 AM
Hi there,
The error message indicates that the command is not supported.
If you are not using hardware for your studies I suggest you use an emulator such as GNS3, EVE-NG or VIRL. These will have the full command sets available.
cheers,
Seb.
03-28-2018 05:37 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide