I'm trying to configure some basic VLANs but I'm not getting it done. I'm confused with the VLAN setup and VLAN port settings.
The following is what I'm trying to setup:
BOX1 & 2 in VLAN6 (connected to port 4&5) (two ESX machines)
BOX3 in VLAN7 (connected to port 3) (iSCSI storage)
BOX4 no VLAN required (open to all VLANs and network, NFS storage) (connected to port 2)
BOX5 in VLAN9 (connected to port 8) (management pc)
Router (internet) connected at port 1)
Now BOX5 is a management box and should have acces to all VLANs & internet.
BOX1&2 should be able to see BOX3 in VLAN7 & BOX4 in VLAN8 and have access to internet
BOX3&4 only need internet access, no access to other VLANs
I notice that the default VLAN in the SLM2008 is VLAN1 and all ports are members.
Could anyone explain how to set this up? The connected router is a E4200 and is supposed to support VLAN tagging. I'm going in circles trying and I can't find any good howto online.
Regards
