I'm not sure if this is the correct place to post. I had snmp link state up down set on my 3750, but with the number of users disconnecting their laptops, it was generating a huge amount of alarms. So we decided it was best to disable. After disabling we are still getting a number of errors, though and generating the following:
SNMP poll failure (NOSUCHNAME) for poll Buffer Failures/Basic_bufferFail and target <ip_address>.
I did sh snmp and see the following errors.
2284 No such name errors
What is this attributed to? And what's the best solution?
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...