Some Commands Not Accepting w r t WCCP Configuration on 3750G switch

[Mohammed Asif C Y]

  Hi,

 I am trying to configure WCCP on Cisco3750G-48PS switches. But one of the Cisco command " ip wccp 53 redirect in" is not accepting on Gig interface. I have tried it by uploading latest IOS image and also tried with different featuresets.

Can someone help me if it can be achieved.

Regards

MAC

[Reza Sharifi]

Hi,

What is the error message when you enter the command?

What is the output of "ip wccp 53 redirect ?" ?

Also, what is your license level? "sh license"

[Mohammed Asif C Y]

Hi,

I am configuring the below commands

interface GigabitEthernet 1/0/47

ip wccp 53 redirect in

It says

Switch(config)#interface Vlan11

Switch(config)#ip wccp redirect exclude in
                          ^
% Invalid input detected at '^' marker.

interface GigabitEthernet 1/0/47

Switch(config-if)#ip wccp 53 redirect in
% Invalid access list name.

Regards

MAC

[Reza Sharifi]

Hi,

What is your license level?

Can you provide  sh license and sh version?

[Mohammed Asif C Y]

Hi Reza,

As requested i have Attached show version and show license in notepad. The command show license is not accepting

Regards

MAC

[Reza Sharifi]

Hi,

Your version should support WCCP.  Also, you have the correct license/image.

Can you try following this document and config WCCP?

This is for 12.2(55), but should also work for your version.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750/software/release/12-2_55_se/configuration/guide/scg3750/swwccp.html

HTH

[Mohammed Asif C Y]

Hi,

Thanks for your input, so ip wccp redirect in command doesn't support in 3750 switches and instead we have configure it as web cache service and use the command ip wccp web-cache redirect in right?

Regards

MAC