SPAN port on CAT OS

[saquib.tandel]

Hi All

How to configure span port on a CAT OS switch 6506, our object is to monitor two vlans ( vlan 5, vlan 6 ) and send the copy to destination port 1/40

can someone guide me on this request

On IOS it goes as ;-
Switch(config)# monitor session 1 source interface fastEthernet0/1
Switch(config)# monitor session 1 destination interface fastEthernet0/10 encapsulation dot1q

thanks

ST

[acampbell]

ST

See if any spanning sessions are already running

Show span

To copy traffic from Vlan 5 & 6 to port 1/40

set span 5-6 1/40 rx enable

To stop

set span disable all

Here is a useful link that will help too.
http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml#topic4

Regards,
Alex.
Please rate useful posts.