SRW224G4 - How send firmware?

[dawid]

                   Hello,

I tried to upload the new firmware and unfortunately I turned off Swith too early. Now when I connect the serial port I did not want to end run the firmware.

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

------ Performing the Power-On Self Test (POST) ------

UART Channel Loopback Test........................PASS

Testing the System SDRAM..........................PASS

Boot1 Checksum Test...............................PASS

Boot2 Checksum Test...............................PASS

Flash Image Validation Test.......................PASS

BOOT Software Version 1.0.2 Built  17-Aug-2006  14:55:46

:::
:::        ::: :::       ::: :::     :::::  :::::::::: :::      ::: ::::::::::
:::        ::: :::::     ::: :::   :::::   ::::     ::: ::::  :::: ::::     :::
:::        ::: ::: :::   ::: ::::::::      ::::          ::::::::  ::::
:::        ::: :::   ::  ::: ::::::::::     ::::::::::     ::::     ::::::::::
:::        ::: :::    :::::: :::    ::::            :::    ::::             :::
:::::::::: ::: :::      :::: :::      :::: :::......:::    ::::    :::......:::
......... ... ...       ... ...       .... ..........     ....     ..........

Linksys SmartSwitch based on 88E6218 with ARM946E-S.
32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...
100%
FAIL !!! Check image for valid file.
Please download a new image.

Downloading code using XMODEM.

Download failed

Perform WARM BOOT ...

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

How to re-upload the firmware?

[Ivan Shirshin]

Hi Dawid,

Please check this guide, page 64:

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2048/administration/guide/SRW-US_v10_UG_A-Web.pdf

Kind Regards,
Ivan

**Please grade this post if you find it useful.

[dawid]

Hi,

Yes! It.s work!

Thank you very much!

Kind Rwgards

- david.

Wiadomość napisana przez ishirshi w dniu 2012-06-04, o godz. 12:44:

Home

Re: SRW224G4 - How send firmware?

created by Ivan Shirshin in LAN, Switching and Routing - View the full discussion

Hi Dawid,

Please check this guide, page 64:

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2048/administration/guide/SRW-US_v10_UG_A-Web.pdf

Kind Regards,

Ivan

**Please grade this post if you find it useful.

Reply to this message by going to Home

Start a new discussion in LAN, Switching and Routing at Home

[Ivan Shirshin]

Welcome, Dawid, glad that everything is fine now! Appreciate if you could mark the correct answer and rate useful posts :-)

Kind Regards,
Ivan