stackwise virtual config

[carl_townshend]

Hi All

I have a quick question about Stackwise virtual

When setting up a switch, I have seen the configs below, my question is, on the second switch, do you still put in hte command stackwise-virtual link 1 ? so basically they match on both switches ?

cheers

Configuring Cisco StackWise Virtual

Route-XP> enable 

Route-XP# configure terminal 

Route-XP(config)# stackwise-virtual 

Route-XP(config-stackwise-virtual)# domain 2 

Cisco StackWise Virtual Link

Route-XP> enable 

Route-XP# configure terminal 

Route-XP(config)#interface TenGigabitEthernet1/0/2 

Route-XP(config-if)#stackwise-virtual link 1 

StackWise Virtual Dual-Active-Detection link 

Route-XP> enable 

Route-XP# configure terminal 

Route-XP(config)#interface TenGigabitEthernet1/0/2 

Route-XP(config-if)#stackwise-virtual dual-active-detection 

[Georg Pauwen]

Hello,

indeed, all commands need to be entered on both switches. The stackwise virtual configs need to match on both switches.

[carl_townshend]

Hi

ho do you decide the primary switch ?

[inderdeeps]

Yes, you need to put all commands in both the switches

http://www.routexp.com/2018/02/introduction-to-cisco-stackwise-virtual.html

Stay connected with : www.routexp.com