04-20-2020 12:11 PM
Hi all,
I want to set static MAC addresses between my two catalyst switches 9200:
SW-1 SW-2
g1/0/10 <-------trunk------- >g1/0/20
Because this is trunk port and it caries VLANs 10,20,30,35,40 should I configure 5 lines?
mac address-table static 1111.1111.1111 vlan 10 interface g1/0/20
mac address-table static 1111.1111.1111 vlan 20 interface g1/0/20
mac address-table static 1111.1111.1111 vlan 30 interface g1/0/20
mac address-table static 1111.1111.1111 vlan 35 interface g1/0/20
mac address-table static 1111.1111.1111 vlan 40 interface g1/0/20
If I had more VLANs, I would need to have one line per VLAN? There is no some kind of vlan range command or something like that?
Thanks
04-20-2020 12:30 PM
Hi,
What are you trying to accomplish with this?
HTH
04-20-2020 12:39 PM
04-20-2020 12:51 PM
Hi,
It is hard to tell without knowing more about the issue you are seeing. This could be an IOS bug or possibly an issue with a device connecting to the network. Can you provide more details?
Thanks,
Reza
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: